YUKEN方向控制閥注意事項 中國臺灣油研YUKEN方向控制閥

安裝螺栓亞盤安裝泰PE閥門（DRG-02）只配有以下
"P" and cylinder port "A" (or "B") is set to 7 MPa
否則就會截斷介質的正常流動
When sub-plates are not used, the
surface should have a good m achined finish
應使介質正常流動方向與閥體上指示的箭頭方向相*
底閥應安裝在水泵吸水管路的底端
For any other specific gravi
ty (G'), the pressure drop ( P') m ay be

YUKEN方向控制閥注意事項 中國臺灣油研YUKEN方向控制閥

obtained from the formula below.
eover torque will be as right side table
子板是可用的從上表子板MNUM BER。
面應具有良好的米achined光潔度
Be sure to use the External Drain
Type Valve of spool type "2" and plug the tank port.
當不使用子板所述米o(hù)unting表
When the pressure of pressure port
Sub-plates are available. Specify
the sub-plate m odel num ber from the table above.

中國臺灣油研YUKEN方向控制閥